Exterior Plaster Installation

Traditional plaster, built to breathe

Exterior plaster is a traditional cement or lime-based coating system, built up in coats over a wire or metal lath base rather than the foam-backed panel used in an EIFS assembly. It's a breathable system, which is why it's often the right call on older masonry homes and additions where sealing the wall behind an insulated panel would trap moisture instead of letting it escape. Dessano installs exterior plaster where the structure and the design intent call for it, matching the coat build-up, texture, and colour to the age and style of the home.

Complete exterior plaster installation services

Correct mix, correct cure time, finish that fits the house.

Plaster is layered the same way stucco is, but the mix design and cure behaviour are different, and getting that difference right is what keeps the wall performing for decades instead of cracking early. Here's what goes into an installation from the lath out.

Substrate and lath preparation

We check the sheathing and building paper before anything goes on the wall, then install self-furring metal or wire lath with proper overlaps, control joints, and terminations at windows, doors, and the foundation line. Skipping the control joints is a common shortcut that shows up later as random cracking across the field of the wall.

Base coat build-up

The base coat is applied and scored into the lath to key in the following coat, then brought to a true, flat plane before anything else happens. Plaster is a hydraulic-set material rather than a simple dry-out coating, so it needs longer, more consistent cure time between coats than an acrylic finish does, and we build the schedule around that rather than around a fixed number of days.

Finish coat and texture matching

The final coat goes on in the texture the homeowner or architect has specified, whether that's a fine sand finish, a smoother hand-troweled surface, or a texture matched to an existing wing of the home. Colour is blended into the mix or applied as a coating depending on the finish type, and we test a sample panel before committing to the full wall.

Why choose Dessano for exterior plaster installation

Plaster fails early most often because a control joint got skipped or a coat got finished before it had properly cured, and once that happens the cracking shows up within a season or two, not years down the line. Our crews lay out control joints before the lath goes up rather than adding them as an afterthought, and we won't trowel a finish coat over a base coat that hasn't set. That discipline is why plaster we install holds its texture and colour well after other coatings in the same neighbourhood have started to crack.

When exterior plaster installation makes sense

Our installation process

Where we install exterior plaster

We install exterior plaster for residential and commercial clients based out of Oakville, with regular work across Burlington, Mississauga, Etobicoke, North York, Vaughan, Richmond Hill, and Markham. Plaster installation runs roughly from April through December in this climate, though we handle quotes and scheduling year-round.

Common questions about exterior plaster installation

Traditional plaster and stucco use similar cement or lime-based coats over lath, while EIFS adds a foam insulation panel underneath. Plaster is breathable, which suits older masonry walls better than a sealed panel system does.

In most cases, yes. We review the existing texture and colour during the site visit and test a sample panel so you can see the match before we commit to the full wall.

Each coat needs real cure time before the next one goes on, since plaster sets chemically rather than just drying. Rushing that step is one of the main reasons plaster walls crack early.