Stucco Re-Cladding

Start fresh from the sheathing out

Re-cladding means removing a failing exterior, whether that's old stucco, EIFS, or another siding, down to the sheathing, then rebuilding with a new stucco or EIFS assembly. It's the right call when repairs would only patch over a bigger problem, such as water damage behind the finish or a drainage plane that was never installed correctly the first time. Dessano handles re-cladding projects across Oakville and the surrounding region, from single-wall sections to full exterior rebuilds.

Complete stucco re-cladding services

Tear-off, sheathing repair, full rebuild.

Re-cladding starts with taking the old finish off and finding out what's actually going on underneath, since that's usually the reason the wall needed re-cladding in the first place. What we find at that stage shapes the rest of the job.

Removal and sheathing inspection

We strip the failing finish and lath back to the sheathing and inspect it for rot, delamination, or water staining. Any damaged sheathing gets replaced before anything new goes back on the wall, since building a new finish over compromised sheathing just repeats the original problem.

Weather barrier and lath or insulation board

Depending on whether the new assembly is traditional stucco or EIFS, we install a new weather-resistive barrier and either wire lath or insulation board, with proper flashing at windows, doors, and other penetrations that were often the actual source of the original failure.

New coat system and finish

The new stucco or EIFS coats go on in sequence, finished in the texture and colour chosen for the project. This is also the point where a homeowner can change the look of the home entirely if the old finish no longer suits it.

Why choose Dessano for stucco re-cladding

A re-clad is only as good as what happens after the old finish comes off and before the new one goes on, and that's the stage where corners get cut on jobs that fail early. We inspect and photograph the sheathing condition before covering it back up, replace what needs replacing rather than working around it, and install flashing details at every penetration instead of relying on caulking to do that job later. That sequence is what keeps a re-clad from becoming another repair call in a few years.

When stucco re-cladding makes sense

Our process

Where we re-clad exteriors

We provide stucco re-cladding services out of Oakville, with projects across Burlington, Mississauga, Etobicoke, North York, Vaughan, Richmond Hill, and Markham. Re-cladding work runs from April through December, with quotes and planning available year-round.

Common questions about stucco re-cladding

If damage is spread across multiple areas of the wall, or repairs keep recurring in the same spots, that usually points to a problem with the assembly itself rather than something a patch can fix. We'll give you an honest assessment during the site visit.

We'll show you what we found, explain what needs to be replaced, and adjust the quote before any new material goes back on the wall. We don't rebuild over damaged sheathing.

Yes, a re-clad is a common time to make that change, since the wall is already open and it's easier to add insulation board at that stage than later.